How to Wear a Juliet Cap Veil and Keep It in Place

In short
A Juliet cap sits on two combs, slightly above and just behind each ear. Bring the front edge to your hairline, slide each comb in upside down and flip it into place, then cross two kirby grips over each comb. It should sit softly, never tight.
A Juliet cap sits on two combs, one on each side of your head, slightly above and just behind the ear. Bring the front edge down to your hairline, slide each comb in upside down and flip it into place, then cross two kirby grips over each comb. Let the cap sit softly rather than tight. That is all it takes, and once you have done it twice it takes about three minutes.
We get asked about this more than anything else we make, so I wanted to put everything in one place. Keep this page open on the morning, or hand it to whoever is doing your hair.
How a Juliet cap is made to sit
A normal veil hangs from one comb at the back of your head. A Juliet cap is different. The tulle is shaped into a soft cap that frames your face, and it is gathered onto a small comb at each side. Those two combs carry the whole veil, so the weight is shared and nothing pulls on the crown.
Before the day
When your veil arrives, take it out of the box and hang it up. Any creases from the journey will drop out in a day or two. If they need help, hang it in the bathroom while you run a hot shower. Please never iron or steam the tulle.
Take the veil to your hair trial. Your hairdresser will want to see where the combs go, and it is the only way to know your hair will hold it. Have ready:
- Your veil
- Four to six kirby grips (bobby pins) in your hair colour
- Dry shampoo or texture spray, if your hair is freshly washed or very fine
- A hand mirror, so you can see the sides
Step 1: Give your hair something to hold
Combs slip on clean, silky hair because there is nothing for the teeth to grip. Spray a little dry shampoo at the roots just above and behind each ear, or backcomb that spot lightly. If someone is doing your hair, ask them to pin a small hidden section just behind each ear for the combs to sit into. Those two little anchors make all the difference.
Step 2: Bring the front to your hairline
Hold the veil by its two combs, with the cap facing forward and the tulle hanging behind you. Lay the front edge on your head so it sits on your hairline, or just in front of it, close to your brows, if you would like a true 1920s look. Easing it back a little reads more modern, but keep the cap well forward of your crown either way.

Step 3: Slide each comb in and flip it
This is the bit that makes it hold. Take one comb and hold it the wrong way round, with the teeth pointing up and away from your head. Rest it against your hair slightly above and just behind your ear. Now flip it over so the teeth point down, and push it back into your hair in one smooth movement. The hair you trapped as you flipped now locks the comb in place.
Do the same on the other side, keeping the two combs level, each one slightly above and just behind the ear.


Step 4: Cross two kirby grips over each comb
Slide one kirby grip in from above and one from below, so they cross over the top of the comb and catch the hair underneath. That cross is what keeps a Juliet cap secure through a long ceremony, a breezy garden and a lot of hugging. Push the grips in so they are hidden under the tulle.
Step 5: Let the cap sit softly
A Juliet cap should never feel tight. It is meant to have a little room, so it rests over your head rather than gripping it. If the top looks pulled or strained, ease the tulle forward with your fingertips until it softens. Our caps are made to fit every head, so there is no need to tighten anything.

Step 6: Check it in the mirror
Look from the front and both sides. The edge should frame your face evenly, the combs should be hidden, and the tulle should fall straight down your back. If your veil has a blusher, bring it forward over your face and check it falls in a soft curve.
If the blusher rises into a point, or the front lifts away from your forehead, the cap is sitting too far back. Take the grips out, bring the whole cap forward and pin it again.

Wearing a Juliet cap with your hair down
A Juliet cap looks lovely with long, loose waves, and it stays put if you give the combs an anchor. Ask your hairdresser to take a thin section from just behind each ear, twist or pin it flat, and set the comb into that. Use the crossed grips in Step 4 every time. If your hair is very fine or slippery, a few extra grips worked through the combs will lock it in completely. Our post on wearing a veil with your hair down has more ways to build in grip.

Wearing a Juliet cap with your hair up
A low bun, a soft chignon or a loose twist at the nape all sit beautifully under a Juliet cap. Keep the volume low at the back, because a high bun pushes the cap up and away from your face. Set the combs just behind your ears before the last pins go into the bun, so the tulle falls cleanly over it.

With a fringe
A full fringe looks wonderful under a Juliet cap. Let the fringe fall first, then bring the front edge of the cap down to sit just behind it, or just over the top of it for a more vintage look.
If it slips, peaks or catches
- It feels loose: take the comb out and go again a little lower, where there is more hair, and cross two grips over it.
- The blusher sits in a point: the cap is too far back. Bring it forward to your hairline.
- The top looks strained: the combs are too far back or too tight. Ease the tulle forward with your fingertips.
- The tulle has caught on something: smooth it gently between your fingers and it will settle.
- One side is higher: check both combs are level, slightly above and just behind each ear.
Taking it off
For the evening, slide the grips out first, then lift each comb up and out the way it went in. Doing it in that order keeps your hair in place and keeps the tulle safe. Lay the veil flat or hang it straight away.
Still unsure?
If something does not look right on the day you try it, just send us a photo and we will help. Our guide to what a Juliet cap veil is covers the history and how to choose one, and all our Juliet cap veils are made to order in our workshop in Bath.
Sarah Jane x
Your questions
Will a Juliet cap veil stay on with my hair down?
Yes. Ask your hairdresser to pin a small flat section just behind each ear, set the combs into those, and cross two kirby grips over each comb. Fine or silky hair may need a couple of extra grips.
Where do the combs go on a Juliet cap?
One on each side of your head, slightly above and just behind the ear. Keep them level so the cap frames your face evenly.
Should a Juliet cap feel tight?
No. It is made to sit softly with a little room over your head. If it feels tight or looks strained, ease the tulle forward with your fingertips.
Why does my blusher sit in a point?
The cap is too far back on your head. Bring the front edge forward to your hairline and pin the combs again.
Can I wear a Juliet cap further back on my head?
A little, for a more modern look. A good hairdresser can set the combs slightly further back, but keep the cap well forward of your crown so it frames your face.
The collection Wedding Veils See the collection